The NIC will issue a Battery-On-Dischargealarm if the plant voltage falls below thisset point (Volts) 11 Vdc 24 Vdc 48 Vdc The NIC will issue a High Voltage Alarm ifthe plant voltage exceeds this set point(Volts) 13 Vdc 28.25 Vdc 57 Vdc Language The language the webpage is displayed. System Current Limit Enables the system current limit feature Disabled Disabled DisabledĬurrent per RectifierThe NIC will limit the current of therectifiers to this value (Amps) 220 A 220 A 220 A The NIC will shut down the rectifiers if theplant voltage exceeds this set point.(Volts) 14 Vdc 29 Vdc 58 Vdc The voltage to which the rectifiers willregulate the plant voltage during floatmode (Volts) 12 Vdc 27 Vdc 54 Vdc Any settings changed from the defaults will have to be reset. NOTE: The rectifiers will change to the new control ler settings uponinstallation. Contact Valeretech support at 1-86 for a copy of your companys controller settings ifdifferent from profile #01. Forexample, using the part number NIC1000-A01-10, the second and third digits inthe second section (in case 01) is the controller profile number. Your profile numbermay be different and can be determined from the part number of the NIC. The values in Table 2 are based on theValere default controller with profile number 01 (PN 01). The controller will arrive already setup with the default settings based on theprofile number. The event of a controller removal, the system will remain at the last knownsettings until a new controller is installed. The controller is hot-swappable, therefore the controller can beremoved or installed while the system is operating without any interruption. See the respective shelf installation & maintenance manual for controller slotlocation. Thru RJ 45 port on the rear of the shelf. In addition,the table provides a description of the products and their uses.įront Ethernet RJ 45 Port and RS-232 thru Table 1 provides a list of products that are covered in this manual. The purpose of this manual is tocover the web interface, Telnet, RS232, and SNMP. The NIC provides a web (GUI) interface for additional control of the Valere J -series and H-series (Mini) power systems. 176.4 SYSTEM CONFIGURATION PAGE (SYS.CONFIG.). Eltek Valere - Ethernet Controller - Operation Manual - V1.1ġ OVERVIEW. Eltek Valere - Ethernet Controller - Operation Manual - V1.1

Eltek valere software